I am no longer maintaining the electronics sections of this site. For an explanation, see the electronics contact page. If you need help, you can ask your question in The Forum.

Microphone Mixer

By Anatoly I. Shikhatov

This relatively simple mixer was designed for three dynamic microphones, but can be re-designed for more or less. Level and tone controls are available to tailor the sound to your needs.

Schematic


Schematic for mixer

Parts:


Part
Total Qty.
Description
Substitutions
R1, R2, R331K 1/4W Resistor
R4, R5, R6310K Logarithmic Pot
R711Meg 1/4W Resistor
R8, R10210K 1/4W Resistor
R9, R112100K Linear Pot
C1, C2, C5, C640.1uF Ceramic Disc Capacitor
C3, C4222nF Ceramic Disc Capacitor
U1, U22741 Op Amp
J1, J2, J33Input Jacks Of Your Choice
MISC1Board, Wire, Knobs, IC Sockets

Notes:

1. Email Anatoly I. Shikhatov with questions, comments, etc.

2. R1-R3 are level controls. R9 and R11 control bass and treble, respectively.

3. Since the circuit draws such low current, two 9V batteries can be used for a power supply.

4. Building the mixer in a metal case will cut down on noise.

Back To Circuits Page | Mail Me | Search