I am no longer maintaining the electronics sections of this site. For an explanation, see the electronics contact page. If you need help, you can ask your question in The Forum.

Simple Phone Tap

By Derek Tombrello

This circuit is extremely simple, therefore there is less chance of any problems. It can be placed anywhere on the phone line and it will record any conversation on any phone on that line.

Please note: I have received several emails saying that this circuit will not work and that it may hold your line off hook and to me it looks like it will (it would put quite a load on teh phone line). Build at your own risk.

Schematic


This the Schematic of the Simple Phone Tap

Parts


Part
Total Qty.
Description
Substitutions
R11470 Ohm 1/4 Watt Resistor
R211K 1/4 Watt Resistor
R31100K 1/4 Watt Resistor
R416K 1/4 Watt Resistor
C1, C220.01 uF 100V Ceramic Capacitor
K1124VDC Reed Relay
MISC1Wire, Headphone Plugs, Phone Plug Or Alligator Clips

Notes

1. Email Derek Tombrello with comments, questions, etc.

2. To use the circuit, simply connect it in series to the phone. Then plug in the recorder. It will start recording when the phone is picked up.

3. The values of R1 and R2 may have to be adjusted, depending on the characteristics of the phone line it is connected to (they vary). If the R1+R2 combination is increased sufficiently (try 2.47K) then the circuit can be connected in parallel with the line, thus covering all attached devices. (Thanks to Mark Wright for the suggestion).

Back to Circuits Page | Mail Me | Search